Difference between revisions of "Training 041024"

Revision as of 23:25, 3 October 2024

Today, Stephen went through all the steps required to make BoSL boards work awesomeomely!

To upload to the BoSL board please find the instructions below:

Ensure that the JUPMER PIN is on the middle two - ON, not OFF or WDT. TIM at TINY to ensure all are ON.

Connect the BoSL board to your computer using the USB port, plug in a battery to the BoSL board

Add the BoSL board package by following the instructions at https://monash-bosl.github.io/BoSL-IDE-Core/

FIRST go to preferences and paste in the above URL.

Click Tools > Board: > Board Manager

Type in BOSL and find the correct board manager - the 0.5 is in the BoSL Boards AVR B - INSTALL THIS.

Tools, boards, bosl, bosl 0.5.

Then go to file, examples and under utilities there should be utilities modem passthrough.

Upload and it should upload via the chosen COM PORT!

Pass through should work - turn off LINE ENDING such that it is NO LINE ENDING.

Try AT return - it should return OK.

@@ Line 4: / Line 4: @@
 ==BOSL 0.5 SETUP==
+Ensure that the JUPMER PIN is on the middle two - ON, not OFF or WDT. TIM at TINY to ensure all are ON.
 Connect the BoSL board to your computer using the USB port, plug in a battery to the BoSL board
@@ Line 20: / Line 23: @@
 Tools, boards, bosl, bosl 0.5.
-Then go to file, examples and under utilities there should be utilities modem passthrough
+Then go to file, examples and under utilities there should be utilities modem passthrough.
+Upload and it should upload via the chosen COM PORT!
+Pass through should work - turn off LINE ENDING such that it is NO LINE ENDING.
+Try AT return - it should return OK.